fpgabist [-h] [-i device_id] [-b bus] [-d device] [-f function] [path_to_gbs1 path_to_gbs2 ...]
fpgabist tool performs self-diagnostic tests on supported FPGA
The tool accepts one or more Accelerator Function (AF) binaries from a predetermined set of AFs. Depending on the available binaries, the tool runs appropriate tests and reports hardware issues.
fpgabist always uses
fpgainfo to report system information
before running any hardware tests.
fpgabist accepts the following AFs: 1. nlb_mode_3: The
native loopback (NLB) test implements a loopback from TX to RX. Use it
to verify basic functionality and to measure bandwidth. 2. dma_afu: The
direct memory access (DMA) AFU test transfers data from host memory to
FPGA-attached local memory.
The installation includes the AF files, but you can also compile the AFs from the source.
If there are multiple PCIe® devices, use -b, -d, -f to specify the BDF for the specific PCIe® device.
[path_to_gbs1 path_to_gbs2 ...]
Paths to Accelerator Function (AF) files.
You can use the single letter or the full parameter name for the command line arguments.
Prints usage information
-i device_id, --device-id device_id
Device ID for Intel FPGA. Default is: 0x09c4
-B bus, --bus bus
Bus number for specific FPGA
-D device, --device device
Device number for specific FPGA
-F function, --function function
Function number for specific FPGA
fpgabist <path_to_gbs_files>/dma_afu.gbs <path_to_gbs_files>/nlb_3.gbs
fpgabist on any platform in the system that matches the default
device ID. This command runs both the DMA and NLB_MODE_3 tests.
fpgabist -i 09c4 -b 5 <path to gbs>/dma_afu.gbs
fpgabist the DMA test on the PCIe® Endpoint with
09c4 on bus 5.
|Date||Intel Acceleration Stack Version||Changes Made|
|2018.10. 15||1.2. (Supported with Intel Quartus Prime Pro Edition 17.1.1.)||No changes from previous release.|
|2018.05. 21||DCP 1.1 Beta (works with Quartus Prime Pro 17.1.1)||Made the